Pearson 39 Standard Equipment (from brochure)
HULL
-
One-piece molded reinforced fiberglass
laminate (hand lay-up) with integrally bonded bulkheads.
-
Standard hull color white. Other
colors optional.
-
Cove stripe; standard colors.
DECK & COCKPIT
-
One-piece molded reinforced fiberglass
laminate (hand lay-up) with balsa core for stiffness and
insulation.
-
Color and non-skid surfaces molded
in.
-
Textured fiberglass full headliner
laminated to deck cabin interior surface.
-
Self-bailing
cockpit.
-
Cockpit sail lockers (P&S) with
molded drain gutters.
-
Lazarette hatch.
-
Fiberglass coamings and winch islands
capped in teak with storage alcoves under.
-
Teak handrails.
-
Deck unit mechanically fastened to
hull with overlay of fiberglass for complete watertight
integrity.
-
Teak toe rail.
-
Choice of standard deck colors.
MACHINERY
-
30 H.P. 4-cylinder gas engine 2:1
reduction.
-
35 amp. alternator. 1" tobin bronze
shaft, shaft strut, propeller, and bronze gland stuffing
box.
-
Stainless steel waterbox type muffler
with steamhose.
-
Controls and instruments inside of
cockpit well include shift, throttle, choke, starter button, ammeter,
oil pressure, and water temperature.
-
30 gal. Monel fuel tank with cockpit
sole deck plate fill and overboard vent.
-
Shut-off valve, fuel filter, and
flexible line.
TANKS & PLUMBING
-
Two 20 gal. Fiberglass water tanks
located in main cabin under (P&S) berths, with deck fills, vents,
and supply lines with shutoff valves.
-
Toilet intake and discharge lines
fitted with bronze seacocks.
-
Vented loop on discharge.
ELECTRICAL
-
Fused switch panel. Master power
switch, 12V 90 AH battery.
-
International navigation
lights.
-
Interior cabin lights.
-
Stranded copper wiring with impervious
covering, color coded for circuit identification and located high above
bilge area.
-
Designed to minimize voltage
drops.
HARDWARE & DECK FITTINGS
-
Chrome-plated brass or bronze,
stainless steel, and special marine alloys, including custom designed
stainless steel stemhead fitting, stainless steel backstay and shroud
chainplates.
-
Bow chocks (P&S), bow cleat, stern
cleats (P&S), and flagpole socket.
-
Four large fixed ports (main cabin),
and 4 small fixed ports.
-
Two small opening ports.
-
Overhead vent hatch in main and
forward cabins.
-
Foredeck plate.
-
Stainless steel genoa tracks through
bolted on teak batten (P&S).
-
Genoa blocks with track
slides.
-
Two primary sheet
winches.
-
Main sheet traveler on
bridge.
-
Stainless steel bow pulpit and stern
rail.
-
Stainless steel stanchions with
vinyl-covered stainless steel lifelines.
-
Edson steerer (model 335) with 5" E.S.
Ritchie compass (chrome dome head optional).
-
Emergency tiller.
SPARS
-
Mast of anodized aluminum 6061-T6
alloy with internal track section, stepped through the
deck.
-
Aluminum spreaders.
-
Custom masthead fitting and stainless
steel tangs.
-
Halyard cleats.
-
Two halyard winches.
-
Boom of anodized aluminum 6061-T6
alloy with internal sail track groove.
-
Fixed gooseneck. Internal clew
outhaul.
-
Topping lift.
-
Mainsheet and blocks.
RIGGING
-
Standing - stainless steel 1 x 19 with
truloc swaged end fittings.
-
Forged turnbuckles for headstay, upper
and lower shrouds.
-
Toggles on upper-lower shrouds and
masthead toggle on headstay.
-
Running - main & jib halyards of 7
x 19 stainless steel with spliced Dacron* tails.
-
Braided Dacron* main and genoa
sheets.
-
Flag halyards.
-
Two sheet winches (chrome) with
cleats.
INTERIOR
-
Sleeping accommodations for five (six
or seven with optional pilot berths).
-
V-berth in forward cabin with
drawer and flap stowage under.
-
Bureau with locker and drawer stowage
to port.
-
Hanging locker to
starboard.
-
Forepeak anchor rode
stowage.
-
Translucent hatch overhead
forward.
-
Shelf stowage P&S.
-
Hinged door privacy.
-
Toilet room has fiberglass sole and
toilet base.
-
Alcoves and sliding door locker
outboard.
-
Vanity equipped with stainless steel
wash basin, manual F.W. pump, trap linen stowage, and locker
under.
-
Mirror with light over.
-
Hinged entry door.
-
Large hanging locker is opposite
toilet room.
-
Main cabin has extension transom
berths port and starboard.
-
Lockers and bookshelves with
upholstered backrests outboard.
-
Foldaway bulkhead mounted
table.
-
Bureau with locker and drawer stowage
is to starboard forward of berths.
-
Quarter-berth and navigation
station (with chart storage) is located aft to port; drawers and locker
under.
-
Stowage shelf above
quarter-berth.
-
Teak companionway ladder.
-
L-shape galley aft to
starboard.
-
Stainless steel galley sink with
manual F.W. pump.
-
Large top loading icebox with foam
in-place insulation.
-
Three burner alcohol stove with oven,
gimballed.
-
Removable countertop unit
over.
-
Large sliding door locker outboard of
galley countertop.
-
Drawers and locker stowage
under.
-
Wet locker and alcohol tank storage
opposite galley next to quarter-berth.
-
Textured fiberglass sole in both
cabins.
-
High pressure laminates on all
countertops.
-
Aft cabin face has recessed areas for
instrument installations.
-
Main bulkheads are covered with
high-pressure laminates (teak veneer optional).
-
Hull sides are covered with veneer
genuwall.
-
Standard berth mattresses are 4" foam;
fabric covered throughout.
-
Teak trim and joiner work
throughout.
-
Choice of contemporary interior décor
colors.
SAFETY EQUIPMENT
-
Bonding system incorporates common
grounding of chainplates, seacocks, engine and fuel tank.
-
Seacocks or gate valve on
thru-hulls.
-
Deck and cockpit areas have molded-in
non-skid surfaces.
-
Self-bailing cockpit. Natural and
forced draft ventilation of engine compartment in accordance with
U.S.C.G. regulations.
-
Manual bilge pump.
-
Life lines.
-
Teak handrails on cabin top.
OPTIONAL EQUIPMENT
A wide selection of factory installed
equipment is available for this boat. See price sheet for complete
details.
*DuPont Registered
Trademark