P26 Standard Equipment

HULL: One-piece molded reinforced fiberglass (hand lay-up) with integrally bonded bulkheads. Standard hull color, white. Other colors optional. Boot top paint: standard colors.

Deck & COCKPIT: One-piece molded reinforced fiberglass laminate (hand lay-up) with balsa core for stiffness and insulation. Color and non-skid surfaces molded in. Textured fiberglass full headliner laminated to deck cabin interior surface. Self-bailing cockpit. Cockpit sail lockers with molded drain gutters. Fiberglass sliding companionway hatch. Drop slides. Fiberglass coamings and winch islands with storage alcoves under. Teak handrails. Deck unit mechanically fastened to hull with overlay of fiberglass for complete watertight integrity. Transom well for mounting optional outboard motor. Fuel tank storage compartments in cockpit. Choice of standard deck colors.

TANKS & PULMBING: 22 gal. Fresh water tank located in forepeak with deck fill, vent, and supply line. Portable toilet system.

ELECTRICAL: Fused switch panel. 12V 53 AH battery. International navigation lights. Interior cabin lights. Stranded copper wiring with impervious covering, color coded for circuit identification and located high above bilge area. Designed to minimize voltage drops.

HARDEWARE & DECK FITTINGS: Chrome-plated brass or bronze, stainless steel, and special marine alloys, including custom designed stainless steel stemhead fitting, stainless steel backstay and shroud chainplates. Bow chocks (P&S), bow cleat, stern cleats (P&S), and flagpole socket. Two large fixed ports (main cabin), and 2 small fixed ports. Overhead hatch, forward cabin. Genoa gear, 2 winches, and cleats; mainsheet blocks and cleat. Bow pulpit and lifelines. Tiller steering.

SPARS: Mast of protective coated aluminum 6061-T6 alloy with internal track section. Aluminum spreaders. Rigging fittings of stainless steel and aluminum alloy. Halyard cleats. Sail track and gate. Boom of protective coated aluminum 6061-T6 alloy with internal sail groove. Topping lift.

Rigging: Standing-super stainless steel 1x19 with truloc swaged end fittings. Turnbuckles for headstay, backstay, upper and lower shrouds. Toggles on upper-lower shrouds and masthead toggle on headstay.

Running-main & jib halyards of 7x19 stainless steel with spliced Dacron* tails. Braided Dacron main and jib sheets.

INTERIOR: Sleeping accommodations for five. Double berth in forpeak with folding door privacy. Trap storage under berth. Forepeak anchor rode storage. Translucent ventilation hatch overhead. Shelf storage P&S. Toilet room with portable toilet system. Storage locker to starboard. In main cabin dinette is to port; converts to double berth with storage under. Single berth to starboard with storage under. Storage shelves outboard, P&S. Galley stove flat aft on starboard side and galley unit with stainless steel sink and manual fresh water pump on port side aft. Provision under companionway step for portable ice chest. Textured fiberglass cabin sole. High pressure laminates in countertops and table. Teak pattern overlays on bulkheads and other interior compartments. 4" foam mattresses, fabric covered. Choice of contemporary décor colors.

SAFTY EQUIPMENT: Bonding system incorporates common grounding of chainplates, stemhead, and seacocks. Deck and cockpit areas have molded-in non-skid surfaces. Self-bailing cockpit. Teak handrails on cabin top. Manual bilge pump.

OPTIONAL EQUIPTMENT: A wide selection of factory installed equipment is available for this boat.